12V LED ladi aur chaser se running lights kaise banayein
SBDH PIXELS ·
12V single colour ladi sasti, safe aur lagane mein aasan hai. Chaser jod dein toh yahi ladi daudti, chamakti running lights ban jaati hai.
Kya-kya chahiye
- 12V LED ladi: 5 inch wali ladi mein 50 bulb aur lagbhag 20 ft lambai; 7 inch wali mein 50 bulb, zyada lambai. Rang: warm white, white, red, green, blue, yellow, pink.
- 12V chaser: 3 channel, 5 running ya 6 channel (18+ designs) board.
- 12V SMPS: ladi ki ginti ke hisaab se (chhote kaam ke liye 12V 10A, bade ke liye 12V 400W).
- 2-pin connector: male aur female jodi, ladi aur power ko pakka jodne ke liye.
- Insulation tape: jodon ko dhakne ke liye.
Kaise lagayein
- Pehle ladi ko jagah par (railing, khidki, deewar) lagaiye.
- Chaser ke saath aaye instructions ke hisaab se ladi ko chaser ke outputs se jodiye. Alag outputs par alag ladi hone se roshni ek se doosre mein daudti hai.
- Chaser ko 12V SMPS se jodiye, phir SMPS ko plug mein lagaiye.
- Saare jodon par tape lagaiye aur SMPS ko baarish se bachaiye.
Bina chaser ke chamak
12V flasher seedhe 12V supply se khud flash karta hai, controller ki zaroorat nahi. Decoration mein sparkle ke liye bahut achha hai.
Sab ladi aur chaser: 12V single colour aur 12V chaser. Power supply ke liye padhiye SMPS kaise chunein.
Confusion ho toh jagah ki photo aur size WhatsApp par bhejiye. Hum sahi set suggest karenge.
